Construction - 6x8 Hut - Materials
| 3D Model (uses Sketchup) | Materials and Cut Guide | Blueprints | Assembly Instructions |
| Panel | 2x4 studs | Plywood sheets | |||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|
| 96" | 91.5" | 72" | 69" | 65" | 62" | 45" | Total | 5/8" | 3/8" | ||
| Floor | 4 | 7 | 11 | 1.5 | |||||||
| Side | 2 | 5 | 7 | 2 | |||||||
| Side | 2 | 5 | 7 | 2 | |||||||
| Back | 4 | 2 | 6 | 1.5 | |||||||
| Front | 4 | 2 | 6 | 1 | |||||||
| Loft | 2 | 4 | 6 | 1.5 | |||||||
| Gable | 1* | 1 | 0.25 | ||||||||
| Gable | 1* | 1 | 0.25 | ||||||||
| Roof | 2* | 0 | 2 | ||||||||
| All | 8 | 18 | 4* | 7 | 4 | 4 | 2* | 45 | 5 | 7 | |
* - All studs for the roof and the gables are cut at an angle; if you are precutting studs before fabrication, please take note of this.
Plus:
- 1 2x6 stud, 96" for roof ridge
- 4 2x4 studs, 24" for ladder
- 7 2x4 studs, at least 6", for loft supports
- 1 2x4 stud, at least 5', for a ladder/loft support
- 1 roll roll roofing, 30ft
- 4 cinder blocks
- 16d nails, cement coated for framing
- 8d nails for skinning
- Roofing tacks
- Caulk
- Paint